Electromagnetic Compatibility (Emc; Guidance And Manufacturer's Declaration - Electromagnetic Emissions - GE Transport Pro Service Manual

Electromagnetic Compatibility (EMC)

Guidance and Manufacturer's Declaration – Electromagnetic
Emissions
Emissions Test
RF Emissions
EN 55011
RF Emissions
EN 55011
Harmonic Emissions
EN 61000-3-2
Voltage Fluctuations/
Flicker Emissions
EN 61000-3-3
B-2
Electromagnetic Compatibility: Electromagnetic Compatibility (EMC)
Changes or modifications to this system not expressly approved by GE
can cause EMC issues with this or other equipment. This system is
designed and tested to comply with applicable regulation regarding EMC
and must be installed and put into service according to the EMC
information stated in this appendix.
WARNING
Use of portable phones or other radio frequency (RF)
emitting equipment near the system may cause
unexpected or adverse operation.
WARNING
The equipment or system should not be used adjacent to,
or stacked with, other equipment. If adjacent or stacked
use is necessary, the equipment or system should be
tested to verify normal operation in the configuration in
which it is being used.
The Transport Pro system is intended for use in the electromagnetic
environment specified below. It is the responsibility of the customer or
user to assure that the system is used in such an environment.
Compliance
Group 1 The equipment uses RF energy only for its internal function. Therefore, its RF
emissions are very low and are not likely to cause any interference in nearby
electronic equipment.
Class A
Class A The equipment is suitable for use in all establishments other than domestic and
those directly connected to the public low-voltage power supply network that
supplies buildings used for domestic purposes.
Complies
Transport Pro
2012659-042
Electromagnetic Environment – Guidance
Revision A