Siemens SITOP UPS1600 Equipment Manual page 193

Note
When shipped by air, as a result of transport regulations for hazardous goods, when
requested, SITOP BAT1600 LiFePO4 battery modules are only charged up to 30 % in the
factory. Always fully charge the batteries before storing for a long period of time. When
supplied, LiFePO4 batteries are internally disconnected, and therefore must first be
connected before charging.
Removal
To remove, carefully pull up the slider ⑩ using a screwdriver (see the subsequent diagram)
and disengage the device at the bottom edge of the DIN rail. Then you can remove the device
from the upper edge of the DIN rail.
Figure 5-7
SITOP UPS1600 / BAT1600 / UPS1100
Equipment Manual, 07.2021, A5E37775406-11-76
Removal example 6EP4132-0JA00-0AY0 (2.5 Ah LiFePO4)
Mounting/removing
5.2 SITOP BAT1600
193