Signal Connector - Siemens SITOP UPS1600 Equipment Manual

Mounting/removing
5.1 SITOP UPS1600
Removal
To remove, carefully open the slider ⑩ using a screwdriver or by hand (see Figure 5-1
Removal (example 6EP4136-3AB00-2AY0) (Page 188)) and disengage the device at the
bottom edge of the DIN rail. Then you can remove the device from the upper edge of the DIN
rail.
Figure 5-1
5.1.1

Signal connector

Mounting
Push connector on socket ④ in the housing.
Removal
To remove the signal connector, press the release lever (4b) (see Figure 5-2
Mounting/removal: Signal connector (Page 188)) and then remove the connector.
Figure 5-2
188
Removal (example 6EP4136-3AB00-2AY0)
Mounting/removal: Signal connector
SITOP UPS1600 / BAT1600 / UPS1100
Equipment Manual, 07.2021, A5E37775406-11-76