Table of Contents
Advertisement
Control Pro 350 Extra Skid
1
Suction hose
3 Carry handle
5 Nozzle 515 (for thick materials, e.g. interior wall paints)
7 Nozzle holder
9 Gun filter: red (1 pc.), white (1 pc.*)
11 High-pressure hose
13 Nozzle 311 (for thin materials, e.g. lacquers)
15 Return hose
17 Inlet filter
19 Pressure gauge
* pre-installed in the filter housing
Coating Materials Suitable for Use
Dispersion and latex paints for interior use.
Water-based and solvent-containing lacquers and glazes. Paints, oils, release agents, synthetic enamels, PVC lacquers, undercoats,
base coats, fillers and anti-rust paints.
Another nozzle size and gun filter must be used, depending on the material to be processed.
i
Thin materials:
Thick materials:
Coating Materials Not Suitable for Use
Materials that contain highly abrasive components, facade paint, caustic solutions and acidic coating substances.
Flammable materials, materials containing acetone or cellulose thinner
In order to ensure compatibility of the coating substance with the materials used to manufacture the device, please
i
contact Wagner Service in cases of doubt.
Field of application
Coating interior walls and outside objects (e.g. garden fences, garage doors, etc.).
Required tools and auxiliary material
•
Wrench (13, 16, 17, 20) and/or adjustable wrench (2 pcs.) and hex key (10 mm)
•
Hex key (2.5 mm)
•
Empty container
•
A large piece of cardboard
•
Covering material
Preparation of the workplace
Sockets and plugs must be masked. Risk of an electric shock as a consequence of sprayed material entering the
socket!
Mask all the areas and objects that are not to be spray painted, or remove them from the work area.
No liability is assumed for damage due to overspray.
Silicate paint corrodes glass and ceramic surfaces upon contact! All such surfaces must therefore be completely
Danger
covered.
Pay attention to the quality of the adhesive tape used. Do not use excessively strong adhesive tape on wallpaper and
i
painted surfaces, in order to avoid damaging these surfaces when removing the tape. Remove adhesive tape slowly
and evenly; do not use jerky movements. Do not leave adhesive tape on surfaces any longer than necessary, in order to
minimise the possibility of residues when removing. Also observe the adhesive tape manufacturer's instructions.
Nozzle 311
Nozzle 515/619
Description (Fig. 1)
2 Pressure regulator with integrated ON/OFF switch
4 Integrated toolbox for nozzles and small parts
6 Spray Gun
8 HEA Filter Set
10 Selector switch
12 Gun extension (30 cm)
14 Nozzle 619 (for thick materials, e.g. interior wall paints.
For coating larger surfaces)
16 Hose connection
18 Inlet valve pusher
20 Operating instructions
Filter red
Filter white
GB
21
Advertisement
Table of Contents
