Preparing The Coating Material - WAGNER FINESPRAY Operating Manual

Hide thumbs Also See for FINESPRAY:

Table of Contents

Available languages

FineSpray

Before using the attachment, read these operating instructions and familiarise

yourself with the operating instructions for the basic unit. The safety instructions

for the basic unit apply to this FineSpray spray attachment.

The FineSpray spray attachment has been especially developed for the application of

low-viscosity materials. The FineSpray spray attachment can be used with all devices with

the CLICK&PAINT SYSTEM.

Coating materials suitable for use

Mordants, glazes, impregnations, oils and other low-viscosity materials

Coating materials not suitable for use

Viscous materials

Interior wall paint (dispersions and latex paint)

Materials that contain highly abrasive components, facade paint, caustic solutions and

acidic coating substances.

Flammable materials.

Preparing the coating material

Observe the manufacturer's instructions for the use of the coating material

on the paint tin or on the technical instruction sheet.

An absolute precondition for the trouble-free operation of the fine-spray system is that

the coating material is uncontaminated. If you have doubts as to the purity of the coating

material, we recommend that you first filter it through a fine sieve.

COATING MATERIAL

Mordants, glazes,

impregnations, oils

Assembly

For assembly, insert the spray attachment into the gun handle so that the two

arrows point at each other. Turn the gun handle 90° in the arrow direction until

it audibly engages. (Fig. 1)

To remove the spray attachment, push the catch (Fig. 1, A) beneath the trigger down and

turn the spray attachment by 90°.

PROCESSING

undiluted

COMMENTS

Use red feed tube filter

Table of Contents