Introduction; Notes - Hearth and Home Technologies Expedition-I Manual

Single burn rate wood-fired heater

Table of Contents

Introduction

Hearth & Home Technologies of Halifax, PA contracted with PFS-TECO to perform EPA

certification testing on the model Expedition-I Wood-Fired Room Heater. All testing was

performed at PFS-TECO's Portland Laboratory in Clackamas, OR.

performed by Sebastian Button.

• Prior to start of testing, 50 hours of conditioning was performed by the

manufacturer in accordance with ASTM E2780.

• Prior to start of testing, the dilution tunnel was cleaned with a steel brush.

• A 1

hour emissions sample train was pulled for all test runs.

• The blower assembly on this appliance is integral to the design and not provided

optionally, therefore no fan confirmation test was performed.

• A total of 2 test runs were completed. Test runs were performed in accordance

with ASTM E2780 for a single burn rate appliance. See the Run Narrative section

for further detail on each run.

Page | 4

Project # 21-661

Model: Expedition-I

All testing was

Table of Contents

Table of Contents