Standard Surround & Cast Trim Kit - Hearth and Home Technologies Expedition-I Manual

H. Standard Surround & Cast Trim Kit
Overall Dimensions
Standard Size 43" x 31"
Large Size 51" x 34"
1. Remove contents from box being careful not to scratch
or damage the cast trim pieces.
2. Lay surround face down on a protected surface to
prevent scratching.
3. Place the peel and stick round felt vibration insulation
pads on the front side in each corner of the top metal
piece and on the back side in each corner of the top cast
piece (Figure 22.1).
(4) Felt Vibration Insulation Pads
Secure
Surrounds to
Cast Trim Kit
Attach Magnets
before installing
Cast Footers
Front View:
Magnet Installed
Figure 22.1
4. Place the corresponding cast trim pieces (2 cast trim
sides and 1 cast trim header) underneath the panel set,
also face down. Align the holes in the metal pieces with
the 5 bosses on the top cast piece and 2 bosses on each
side piece.
5. Secure the magnet to the bracket. The magnet is facing
the front (Figure 22.2).
Attach magnet like shown above
Figure 22.2
22
Part Number
CT1-4331
CT1-5134
Cast Footers:
Left & Right
Front of
Surround
6. Place the cast footers under the metal sides aligning the
top and bottom holes in the cast footers and metal sides.
7. The 9 mounting clips are shipped in one long strip. Hand
break apart or use pliers.
8. Each clip has a clearance notch to allow room for the
cast on the insert. Place the clip so the notch is facing
the outer edges of the surrounds (Figure 22.3).
Figure 22.3
9. It is best to install all of the 1/4-20 screws only half
way at first to allow for adjustments. After adjustment,
tighten the 2 screws in each cast footer first and then
work your way around to the rest.
10. Slide surround and trim over the top of the insert into
place matching the mounting tabs on the metal sides
with the slots on the insert (Figure 22.4).
11. Align the 2 screws in the top metal surround piece to the
2 alignment holes on the appliance top. Secure in place
(Figure 22.4).
Top: over lip on
top of appliance
Sides: through cut outs on sides and
then down
Figure 22.4
7094-802A
Clearance Notch
04/21