Hearth and Home Technologies Expedition-I Manual page 124

There are many ways to build a fire. The basic principle
is to light easily-ignitable tinder or paper, which ignites
the fast burning kindling, which in turn ignites the slow-
burning firewood.
Here is one method that works well:
1. Activate ACC.
2. Place several wads of crushed paper on the firebox floor.
Heating the flue with slightly crumpled newspaper before
adding kindling keeps smoke to a minimum.
3. Lay small dry sticks of kindling on top of the paper.
4. Make sure that no matches or other combustibles are in
the immediate area of the appliance. Be sure the room is
ventilated and the flue unobstructed.
5. Light the paper in the appliance. NEVER light or rekindle
fire with kerosene, gasoline, or charcoal lighter fluid; the
results can be fatal.
6. Once the kindling is burning quickly, add several full-
length logs 3 to 4 inches (76 - 102mm) in diameter. Be
careful not to smother the fire. Stack the pieces of wood
1/2 to 1 inch apart (13-25mm); near enough to keep
each other hot, but far enough away from each other to
allow air flow between them.
7. Activate the timer system (ACC).
- This livens up the coal bed and reduces excessive
emissions (opacity/smoke).
- Open door slowly so that ash or smoke does not exit
appliance through opening.
- Large logs burn slowly, holding a fire longer.
- Small logs burn fast and hot, giving quick heat.
8. As long as there are hot coals, repeating steps 6 through
7 will maintain a continuous fire.
Fuel reloading:
1. This appliance has a large door with an exceptional
view of the fire.
- Door opens 26 inches (660mm) which goes beyond
the standard size hearth pad covering the floor in
front of the appliance.
- May want to use a hearth rug in front of the hearth
pad to protect the flooring from ash spillage and
continuous cleaning of carpet, etc.
2. Open door slowly so that ash or smoke does not exit
appliance through opening.
- Check the level of the ash build-up. Remove ash if it
reaches the top of the brick covers. Ash should not be
spilling over the brick covers onto the ash lip.
- Any ash or coals on the ash lip can be pressed into
the door gasket and shorten the life of the gasket.
- If the ash is left to accumulate on the ash lip it can
interfere with the door closing and/or falling out onto
the hearth pad or beyond.
Check the ash level each time you reload.
13
NOTE: Build fire on brick firebox floor. Do NOT use
grates, andirons or other methods to support fuel. It will
adversely affect emissions.
Fire Risk.
Do NOT store wood:
• Closer
combustibles to appliance
• Within space required for loading or
ash removal.
Do NOT operate appliance:
• With appliance door open.
• With ash removal system door open.
Figure 13.1
Ceramic Blanket on Top
Figure 13.2
Fire Risk.
• Do NOT burn wet or green wood.
• Store wood in dry location.
• Stack wood so both ends are exposed
to air.
Wet, unseasoned wood can cause accumulation of
creosote.
7094-803A
WARNING
than required clearances
Baffle Board even with front
tube & resting on all tubes
Start-Up Air
Control
Tube Channels
2 pc Baffle Board
WARNING
to
04/21