Operating The Projector; Operating The Projector; Switching The Projector On; Switching The Projector Off - Digital Projection INSIGHT Dual Laser 4K Series Installation And Quick Start Manual

Digital Projection INSIGHT Dual Laser 4K Series

Operating The Projector

Switching the projector on

1. Connect the power cable between the mains supply and the socket
ON/OFF switch
2 .
2. Wait until the self-test has completed and the standby indicator on the projector keypad shows
amber. The light source will be off and the projector will be in STANDBY mode.
3. Press ON on the remote control or the control panel and hold for three seconds, to switch the
projector ON. The power indicator on the control panel will show green, the light source will light
and the shutter will open.

Switching the projector off

1. Press OFF on the remote control or the keypad, and hold for three seconds. The power indicator
on the keypad will show amber, the light source will go out and the cooling fans will run for a short
time until the projector enters STANDBY mode.
2. If you need to switch the projector off completely, switch off at the mains power switch next to the
power connector and then disconnect the power cable from the projector.
Installation and Quick-Start Guide

OPERATING THE PROJECTOR

. Switch on at the
1
Notes
Connecting The Power
See also
Supply earlier in this guide.
Do not turn off the projector from
the power switch or disconnect
the power cord while the
projector is working or cooling
down.
Use only the power cable
provided.
Ensure that the power outlet
1
includes a ground connection as
this equipment MUST be earthed.
2
Handle the power cable carefully
and avoid sharp bends. Do not
use a damaged power cable.
Rev A October 2017
page 16