Digital Projection Mercury Quad Series
Operating The Projector
Switching the projector on
1.
Ensure a lens is fitted. Connect the power cable between the mains supply and the projector. (See Connecting the power supply
above.) Switch on at the switch next to the power connector.
2.
The
indicator lights red to signal that the projector is in STANDBY mode. Press one of the following buttons:
POWER
•
On the remote control, the
ON
•
On the projector control panel, the
The fans begin working, then the
both light steady green. The projector is switched on.
Switching the projector off
1.
Press
on the remote control or
OFF
The
indicator on the control panel will start flashing amber, the system will go out and the cooling fans will run for a short time
POWER
until the
POWER
indicator goes stready red to indicate that the projector has entered STANDBY mode.
2.
If you need to switch the projector off completely, switch off at the mains power switch next to the power connector and then disconnect
the power cable from the projector.
Installation and Quick-Start Guide
button
POWER
button.
POWER
indicator begins flashing green. When the flashing stops, the
on the control panel, then press again to confirm your choice.
POWER
OPERATING THE PROJECTOR
POWER
and
See also
Supply
Use only the power cable
provided.
LIGHT
indicators
Ensure that the power outlet
includes a ground connection as
this equipment MUST be earthed.
Handle the power cable carefully
and avoid sharp bends. Do not
use a damaged power cable.
Notes
Connecting The Power
earlier in this guide.
Rev A March 2017
page 19