Table of Contents
Advertisement
Digital Projection HIGHlite Laser II 3D Series
Operating The Projector
Switching the projector on
1.
Ensure a lens is fitted. Connect the power cable between the mains supply and the projector. (See Connecting the power supply
above.) Switch on at the switch next to the power connector.
2.
The
indicator lights red to signal that the projector is in STANDBY mode. Press one of the following buttons:
POWER
•
On the remote control, the
ON
•
On the projector control panel, the
The fans begin working, then the
both light steady green. The projector is switched on.
Switching the projector off
1.
Press
on the remote control or
OFF
The
indicator on the control panel will start flashing amber, the system will go out and the cooling fans will run for a short time
POWER
until the
POWER
indicator goes stready red to indicate that the projector has entered STANDBY mode.
2.
If you need to switch the projector off completely, switch off at the mains power switch next to the power connector and then disconnect
the power cable from the projector.
Installation and Quick-Start Guide
button
POWER
button.
POWER
indicator begins flashing green. When the flashing stops, the
on the control panel, then press again to confirm your choice.
POWER
OPERATING THE PROJECTOR
POWER
and
See also
Supply
The self-test is running when all the
LEDs on the control panel are lit.
Use only the power cable
LIGHT
indicators
provided.
Ensure that the power outlet
includes a ground connection as
this equipment MUST be earthed.
Handle the power cable carefully
and avoid sharp bends. Do not
use a damaged power cable.
Notes
Connecting The Power
earlier in this guide.
Rev B December 2016
page 17
Advertisement
Table of Contents
