Settings Related To Waiting Time; Waiting Time To Enter Power Saving Mode [Power Saving] - Fujitsu fi-65F Operator's Manual

Chapter 7 Operational Settings

7.5 Settings Related to Waiting Time

Waiting Time to Enter Power Saving Mode [Power
saving]
The waiting time for the scanner to enter power saving mode
can be specified.
1
Start up the Software Operation Panel.
For details, refer to "7.1 Starting Up the Software Operation Panel"
(page 56).
2
From the listing on the left, select [Device Setting].
3
Use the slider to specify the waiting time before entering
power saving mode.
The value can range from 5 to 235 minutes (in increments of 5).
ATTENTION
When the [Power off after a certain period of time] check box is
selected, the scanner may not be turned on when the computer is
turned on.
If the scanner is not turned on when the computer is turned on,
press the [Power] or [Scan] button to turn on the scanner.
HINT
Selecting the [Power off after a certain period of time] check box
turns the power off automatically if the scanner is left on for a
certain period of time without being used.
You can select the timeout period for the scanner to be
automatically turned off by [1 Hour]/[2 Hours]/[4 Hours]/[8 Hours].
4
Click the [OK] button.
A confirmation message appears.
5
Click the [OK] button.
The settings are saved.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Scan
Documents
Configuring the
Scan Settings
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Appendix
Glossary
67