Chapter 7 Operational Settings
7.6 Settings Related to Waiting Time
Waiting Time to Enter Power Saving Mode [Power
saving]
The waiting time for the scanner to enter power saving mode
can be specified.
1
Start up the Software Operation Panel.
For details, refer to
"7.1 Starting Up the Software Operation Panel"
(page
62).
2
From the listing on the left, select [Device Setting].
3
Use the slider to specify the waiting time before entering
power saving mode.
The value can range from 5 to 235 minutes (in increments of 5).
HINT
By selecting the [Power off after a certain period of time] check
box, the scanner turns off automatically if the scanner is left on for
a certain period of time without being used.
You can select a period of time for the scanner to automatically
turn off from [1 Hour]/[2 Hours]/[4 Hours]/[8 Hours].
TOP
Contents
Index
Introduction
Scanner
Overview
How to Scan
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Appendix
Glossary
79