Chapter 8 Operational Settings
HINT
When [Continuous Feed Mode] is enabled, the scanner will wait
for the next document to be loaded until the specified time
elapses even if you start scanning with no document in the ADF
paper chute (feeder).
When the feed mode switch is set to Manual/Single mode, even
if the Enable option is selected for [Continuous Feed Mode] in
[Manual Feeding], the scanner operates in Manual/Single
mode.
This setting can also be configured with the operator panel.
Waiting Time for the Scanner to Enter Power
Saving Mode [Power saving]
The waiting time for the scanner to enter power saving mode
can be specified.
1
Start up the Software Operation Panel.
For details, refer to
"8.1 Starting Up the Software Operation Panel"
(page
156).
2
From the listing on the left, select [Device Setting].
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
202