Parksense Front/Rear Park Assist; System - If Equipped - Jeep WRANGLER 2020 Owner's Manual

STATIONARY OBJECTS AND VEHICLES
ACC does not react to stationary objects and
stationary vehicles. For example, ACC will not
react in situations where the vehicle you are
following exits your lane and the vehicle ahead
is stopped in your lane. Always be attentive and
ready to apply the brakes if necessary.
Stationary Object And Stationary Vehicle Example

PARKSENSE FRONT/REAR PARK ASSIST

SYSTEM — IF EQUIPPED
The ParkSense Park Assist system provides
visual and audible indications of the distance
between the rear, and if equipped, the front
fascia/bumper and a detected obstacle when
backing up or moving forward (e.g. during a
parking maneuver). For limitations of the
system, see Ú page 178.
NOTE:
The system is designed to assist the driver

and not to substitute the driver.
The driver must stay in full control of the

vehicle's acceleration and braking and is
responsible for controlling the vehicle's
movements.
STARTING AND OPERATING
ParkSense will retain the last system state
(enabled or disabled) from the last ignition cycle
when the ignition is placed in the ON/RUN
position.
ParkSense can be active only when the gear
selector is in REVERSE or DRIVE. If ParkSense is
enabled at one of these gear selector positions,
the system will remain active until the vehicle
speed is increased to approximately 7 mph
(11 km/h) or above. A warning will appear in the
instrument cluster display indicating the vehicle
is above ParkSense operating speed. The
system will become active again if the vehicle
speed is decreased to speeds less than
approximately 6 mph (9 km/h).
173
4