Jeep WRANGLER 2020 Owner's Manual page 37

Door Removal Warning Label
WARNING!
All occupants must wear seat belts during

off-road operation with doors removed. For
off-road driving tips, see Ú page 198.
Do not store detached doors inside of the

vehicle, as they may cause personal injury
in the event of an accident.
NOTE:
Doors are heavy; use caution when removing

them.
Hinge pin can break if overtightened during

door reinstall (Max Torque: 7.5 ft· lb/10 N· m ).
For off-road driving tips, see Ú page 198.
1. Roll down the glass window to prevent any
damage.
2. Remove the hinge pin screws from the
upper and lower outside hinges (using a
#T50 Torx head driver).
NOTE:
The hinge pin screws and nuts can be stowed in
the rear cargo tray located under the rear load
floor.
Hinge Pin Screw
3. Slide the front seat(s) fully forward.
4. Pry open and remove the plastic wiring
access door from the bottom of the B-pillar.
GETTING TO KNOW YOUR VEHICLE
Wiring Access Door
5. Unplug the wiring connector.
NOTE:
Squeeze the tab on the base of the wiring
harness. This will unlock the connector tab,
allowing the wiring connector to be unplugged.
Wiring Connector
35
2