Jeep WRANGLER 2020 Owner's Manual page 505

Hide thumbs Also See for WRANGLER 2020:
Table of Contents

Advertisement

T
T
O
T
V
O
URN
FF
HE
EHICLE
ENGINE START/STOP B
1. Place the gear selector in PARK, then push
and release the ENGINE START/STOP
button.
2. The ignition button indicator will return to
the OFF position.
3. If the gear selector is not in PARK, with
vehicle speed less than 5 mph (8 km/h),
when the ENGINE START/STOP button is
pushed, the instrument cluster display will
display a "Vehicle Not In Park" message,
and the vehicle will remain running.
4. If the gear selector is not in PARK, with
vehicle speed greater than 5 mph (8 km/h),
when the ENGINE START/STOP button is
pushed continuously for at least two
seconds (or three short pushes in a row),
the vehicle ignition mode will exit Drive
"Ready" mode and enter "Accessory" mode.
Never leave a vehicle out of the PARK
position, or it could roll.
U
NOTE:
SING
UTTON
This vehicle is equipped with an automatic
shutdown feature. If the vehicle is left in a
"READY" state (vehicle running) with the gear
selector in "PARK" for 30 minutes, the
vehicle will automatically turn itself off.
The vehicle provides automatic notification
using a three horn chirp alert, cluster
chiming, and a cluster message ("Key Fob
has Left the Vehicle") if the vehicle was not
turned off (still "Ready to Drive") and a valid
fob for the vehicle is not detected within the
passenger cabin, following the opening and
closing of any passenger compartment door
(requires all doors to be closed before the fob
check will occur). These automatic alerts are
to remind the driver to turn off the vehicle
before leaving it, as well as, to let the driver
know that the vehicle's fob may have been
unintentionally removed from the vehicle by
an exiting passenger. After providing the horn
chirp alert, additional auto chirps will be
inhibited until the gear selector has been
moved out of PARK or ignition cycled.
STARTING AND OPERATING
AUTOMATIC TRANSMISSION
CAUTION!
Shift into or out of PARK or REVERSE only
after the vehicle has come to a complete
stop.
Do not shift between PARK, REVERSE,
NEUTRAL, or DRIVE when the engine is
above idle speed.
Before shifting into any gear, make sure
your foot is firmly pressing the brake pedal.
NOTE:
You must press and hold the brake pedal while
shifting out of PARK.
WARNING!
Never use the PARK position as a substi-
tute for the parking brake. Always apply the
parking brake fully when exiting the vehicle
to guard against vehicle movement and
possible injury or damage.
43
4
(Continued)

Advertisement

Table of Contents
loading

Table of Contents