Jeep WRANGLER 2020 Owner's Manual page 88

86 GETTING TO KNOW YOUR VEHICLE
4. Making sure the lift assist mechanism is in
the "lock" position, lift the soft top into the
rear of the vehicle with the side links
pointing toward the front. Lower the lift
assist mechanisms onto its retainers on
both sides (on the inside of the sport bar).
Step Four
Step Four
5. Using the provided #40 Torx head driver
and ratchet, tighten the Torx screws by
turning them clockwise. Secure them until
they are snug (refer to the table below for
recommended torque specifications), being
careful not to cross-thread the screws or
overtighten. Repeat on the opposite side.
Step Five
1 — Lock Position
2 — Torx Head Screw
3 — Torx Head Screw
Torque
Specification
Maximum
For Torx
Screws
119.5 in-lb 150.5 in-lb
(13.5 N·m) (17.0 N·m)
CAUTION!
Do not overtighten the screws. You can strip
the screws if they are overtightened.
Minimum
106.2 in-lb
(12.0 N· m )