Jeep WRANGLER 2020 Owner's Manual page 276

274 SAFETY
Medium

When the sensitivity of FCW is set to the

"Medium" setting and the system status
is "Only Warning", this allows the system
to warn the driver of a possible collision
with the vehicle in front using audible/
visual warnings.
Near

When the sensitivity of FCW is set to the

"Near" setting and the system status is
"Only Warning", this allows the system to
warn the driver of a possible closer colli-
sion with the vehicle in front using
audible/visual warnings.
This setting provides less reaction time

than the "Far" and "Medium" settings,
which allows for a more dynamic driving
experience.
More dynamic or aggressive drivers that

want to avoid frequent warnings may
prefer this setting.
FCW Limited Warning
If the instrument cluster displays "ACC/FCW
Limited Functionality" or "ACC/FCW Limited
Functionality Clean Front Windshield"
momentarily, there may be a condition that
limits FCW functionality. Although the vehicle is
still drivable under normal conditions, the active
braking may not be fully available. Once the
condition that limited the system performance
is no longer present, the system will return to its
full performance state. If the problem persists,
see an authorized dealer.
Service FCW Warning
If the system turns off, and the instrument
cluster displays:
ACC/FCW Unavailable Service Required

Cruise/FCW Unavailable Service Required

This indicates there is an internal system fault.
Although the vehicle is still drivable under
normal conditions, have the system checked by
an authorized dealer.
FCW Sensor Protective Cover
Your vehicle is equipped with a protective cover
that is to be used whenever the windshield is
folded down in order to protect the FCW sensor.
To install the cover, follow the instructions
below.
1. Secure the top part of the cover so that it
hinges to the header.
2. Swing the cover down and push on it so that
it covers the opening.
3. Check to make sure the cover is secured
properly.
NOTE:
Be sure to remove the cover before returning
the windshield to the normal position. Store the
cover in the cargo area.
Cleaning Instructions
During windshield down applications, dust/dirt
can accumulate in the cover and block the
camera lens. Use a microfiber cloth to clean the
camera lens, module, and inside cover, being
careful not to damage or scratch the module.