Enabling And Disabling Parksense; Service The Parksense Park Assist System; Cleaning The Parksense System; Parksense System Usage Precautions - Jeep WRANGLER 2020 Owner's Manual

178 STARTING AND OPERATING
E A D
NABLING ND ISABLING
ParkSense can be enabled and disabled with
the ParkSense switch located below the
Uconnect display.
When the ParkSense switch is pushed
to disable the system, the instrument
cluster display will show the
"PARKSENSE OFF" message for
approximately five seconds.
When the gear selector is moved to REVERSE
and the system is disabled, the instrument
cluster display will show the "PARKSENSE OFF"
message for as long as the vehicle is in
REVERSE.
The ParkSense switch LED will be on when
ParkSense is disabled or requires service. The
ParkSense switch LED will be off when the
system is enabled. If the ParkSense switch is
pushed, and the system requires service, the
ParkSense switch LED will blink momentarily,
and then the LED will be on.
P S S T
ARK ENSE ERVICE HE
S
YSTEM
During vehicle start up, when the ParkSense
System has detected a faulted condition, the
instrument cluster will actuate a single chime,
once per ignition cycle, and it will display the
"PARKSENSE UNAVAILABLE WIPE REAR
SENSORS", "PARKSENSE UNAVAILABLE WIPE
FRONT SENSORS" or "PARKSENSE
UNAVAILABLE SERVICE REQUIRED" message.
When the gear selector is moved to REVERSE
and the system has detected a faulted
condition, the instrument cluster display will
display a "PARKSENSE UNAVAILABLE WIPE
REAR SENSORS" or "PARKSENSE
UNAVAILABLE SERVICE REQUIRED" message
overlay on the side of the detected fault. The
ParkSense system will still function normally on
the non-faulted side.
If "PARKSENSE UNAVAILABLE WIPE REAR
SENSORS" or "PARKSENSE UNAVAILABLE WIPE
FRONT SENSORS" appears in the instrument
cluster display make sure the outer surface and
the underside of the rear fascia/bumper and/or
front fascia/bumper is clean and clear of snow,
ice, mud, dirt or other obstruction and then
P S P A
ARK ENSE ARK SSIST
cycle the ignition. If the message continues to
appear, see an authorized dealer.
If the "PARKSENSE UNAVAILABLE SERVICE
REQUIRED" message appears in the instrument
cluster display, see an authorized dealer.
C T P S
LEANING HE ARK ENSE
Clean the ParkSense sensors with water, car
wash soap, and a soft cloth. Do not use rough or
hard cloths. In washing stations, clean sensors
quickly keeping the vapor jet/high pressure
washing nozzles at least 4 inches (10 cm) from
the sensors. Do not scratch or poke the
sensors. Otherwise, you could damage the
sensors.
P S S U
ARK ENSE YSTEM SAGE
P
RECAUTIONS
NOTE:
Ensure that the front and rear bumpers are

free of snow, ice, mud, dirt and debris to keep
the ParkSense system operating properly.
Jackhammers, large trucks, and other vibra-

tions could affect the performance of
ParkSense.
S
YSTEM