Keyless Enter-N-Go - Passive Entry - Jeep WRANGLER 2020 Owner's Manual

28 GETTING TO KNOW YOUR VEHICLE
K E -N-G — P
EYLESS NTER O
E (I E )
NTRY F QUIPPED
The Passive Entry system is a feature that
allows you to lock and unlock the vehicle's
door(s) and swing gate without having to push
the key fob lock or unlock buttons.
NOTE:
Passive Entry may be programmed on/off

within the Uconnect Settings Ú page 209.
The key fob may not be detected by the

vehicle Passive Entry system if it is located
next to a mobile phone, laptop, or other elec-
tronic device; these devices may interfere
with the key fob's wireless signal and prevent
the Passive Entry system from locking/
unlocking the vehicle.
Passive Entry Unlock initiates illuminated

approach (low beams, license plate lamp,
position lamps) for whichever time duration
is set between 0, 30, 60 or 90 seconds.
Passive Entry Unlock also initiates two
flashes of the turn signal lamps.
If wearing gloves, or if it has been raining/

snowing on the Passive Entry door handle,
the unlock sensitivity can be affected,
resulting in a slower response time.
If the vehicle is unlocked by Passive Entry
ASSIVE

and no door is opened within 60 seconds, the
vehicle will relock and if equipped will arm
the Vehicle Security system.
To Unlock From The Driver or Passenger Side
With a valid Passive Entry key fob within 5 ft
(1.5 m) of the door handle, grab the handle to
unlock the vehicle. Grabbing the driver's door
handle will unlock the driver door automatically.
Grabbing the passenger door handle will unlock
all doors and the swing gate automatically.
Grab The Door Handle To Unlock
NOTE:
Either the driver door only or all doors will
unlock when you grab hold of the front driver's
door handle, depending on the selected setting
in the Uconnect system Ú page 209.
Frequency Operated Button Integrated Key
(FOBIK-Safe)
To minimize the possibility of unintentionally
locking a Passive Entry key fob inside your
vehicle, the Passive Entry system is equipped
with an automatic door unlock feature which
will function only if the ignition switch is in the
OFF position.
FOBIK-Safe only executes in vehicles with a
START/STOP ignition. There are three situations
that trigger a FOBIK-Safe search in any passive
entry vehicle:
A lock request is made by a valid Passive

Entry key fob while a door is open.
A lock request is made by the Passive Entry

door handle while a door is open.
A lock request is made by the door panel

switch while the door is open.
When any of these situations occur, after all
open doors are shut, the FOBIK-Safe search will
be executed. If it finds a Passive Entry key fob
inside the vehicle, the vehicle will unlock and
alert the customer. If Passive Entry is disabled
using Uconnect system, the key protection
described in this section remains active/
functional.