Jeep WRANGLER 2020 Owner's Manual page 492

30 GETTING TO KNOW YOUR VEHICLE
WARNING!
Sitting in a seat with the head restraint in its
lowered position could result in serious injury
or death in a collision. Always make sure the
outboard head restraints are in their upright
positions when the seat is to be occupied.
To raise the center head restraint, lift up on the
head restraint. To lower the center head
restraint, push the adjustment button, located
at the base of the head restraint, and push
down on the head restraint.
Center Head Restraint
1 — Adjustment Button
2 — Release Button
NOTE:
Lower the center head restraint to avoid contact
with the seat bottom cushion when folding the
seat down.
To remove the center head restraint, push the
release button and the adjustment button at
the same time while pulling upward on the head
restraint.
To reinstall the head restraint, put the head
restraint posts into the holes and push
downward. Then, adjust the head restraint to
the appropriate height. Refer to "Occupant
Restraint Systems" in "Safety" in the Owner's
Manual for information on child seat tether
routing.
WARNING!
A loose head restraint thrown forward in a

collision or hard stop could cause serious
injury or death to occupants of the vehicle.
Always securely stow removed head
restraints in a location outside the occu-
pant compartment.
WARNING! (Continued)
ALL the head restraints MUST be rein-

stalled in the vehicle to properly protect the
occupants. Follow the re-installation
instructions above prior to operating the
vehicle or occupying a seat.
HOOD
O
PENING
Always place the ignition in the OFF position
before opening the hood. If the ignition is in
the RUN position and the Propulsion System
is active when the hood is opened, the engine
will automatically start, and persons not clear
of the vehicle could be injured by the engine's
moving parts.
(Continued)
WARNING!