Jeep WRANGLER 2020 Owner's Manual page 471

HIGH VOLTAGE CHARGING OPERATION
T 2 C I
YPE HARGING NLET
Your vehicle uses an industry standard charge
port inlet for both Mode 2 and Mode 3 charging.
Vehicle Charge Inlet Location
M 2 C (230 V)
ODE HARGING
Your vehicle is equipped with a 230 V AC
charging cable. Mode 2 charging requires a
conventional grounded wall receptacle along
with the charging cable provided with the
vehicle, shown below.
Mode 2 Charging Cable (230 V AC)
1 — Charge Connector
2 — Status Indicator Display
3 — Charge Cable
4 — AC Plug
WARNING!
INSTRUCTIONS PERTAINING TO A RISK OF
FIRE OR ELECTRIC SHOCK: Shock, fire,
property damage, or personal injury may
occur if the charging cable is not used
properly. There are no serviceable parts
contained in the charging cable. Any attempt
to service it may result in shock, fire, property
damage, or personal injury.
GETTING TO KNOW YOUR VEHICLE
The charging cable is stored in the rear cargo
area below the load floor. To access this area,
lift up the cargo strap of the load floor cover,
and remove the charging cable from the storage
bag in the bin below.
Moving, Transporting, And Storage Instructions
After use, the charging cable should be placed
in the storage bag and put back in the cargo
storage area. If the charging cable will be left
outside the vehicle, be sure to protect the
device's connection end from moisture, dirt,
debris, accumulation, and contamination.
Load Floor Cover
9
2