Installing The Hard Top - Jeep WRANGLER 2020 Owner's Manual

10. Secure the wire harness to the body side by
plugging it into the receptacle and
reengaging the locking tab.
Step Ten
11. Secure the washer hose by snapping it into
the top of the body side receptacle.
Step Eleven
Step Eleven
12. Lower the rear window, and close the swing
gate.
13. Remove the hard top from the vehicle.
Place the hard top on a soft surface to
prevent damage.
CAUTION!
The removal of the rear Hard Top requires
four adults, one located on each corner.
Failure to follow this caution could damage
the Freedom Top.
GETTING TO KNOW YOUR VEHICLE
I T H T
NSTALLING HE ARD OP
If the door frames are installed from soft top
usage, they must be removed prior to
installation of the hard top. For removal
procedures, see Ú page 98.
To install the hard top, place the hard top on the
vehicle while making sure that the top is sitting
flush with the body at the sides and check to
ensure that there is a uniform gap between the
lift glass and hard top. Then follow the removal
steps in reverse order.
NOTE:
Inspect the hard top seals for damage and

replace if necessary.
The Torx fasteners that attach the hard top to

the body should be torqued as follows using
the provided #50 Torx head driver and
ratchet:
Hard top to B-pillar: 119 in-lb +/- 23 in-lb

(13.5 N·m +/- 2.7 N·m)
Hard top to J-rail: 154 in-lb +/- 30 in-lb

(17.5 N·m +/- 3.5 N·m)
93
2