Parksense Front/Rear Park Assist; System - If Equipped - Jeep 2022 CHEROKEE Owner's Manual

STATIONARY OBJECTS AND VEHICLES
ACC does not react to stationary objects or
vehicles. For example, ACC will not react in
situations where the vehicle you are following exits
your lane and the vehicle ahead is stopped in your
lane. It will consider this stopped vehicle a
stationary object as it did not previously detect
movement from it. Always be attentive and ready
to apply the brakes if necessary.
Stationary Object And Stationary Vehicle Example

PARKSENSE FRONT/REAR PARK ASSIST

SYSTEM — IF EQUIPPED
The ParkSense Park Assist system provides visual
and audible indications of the distance between
the rear, and if equipped, the front fascia/bumper
and a detected obstacle when backing up or
moving forward (e.g. during a parking maneuver).
The vehicle brakes may be automatically applied
and released when performing a reverse parking
maneuver if the system detects a possible collision
with an obstacle.
NOTE:
The driver can disable the automatic braking

function by turning ParkSense off via the Park-
Sense switch. The driver can also override auto-
matic braking by changing the gear or by
pressing the gas pedal over 90% of its capacity
during the braking event.
Automatic brakes are not available if the vehicle

is in 4WD Low.
Automatic brakes will not be available if there is

a faulted condition detected with the ParkSense
Park Assist system or the Braking System
Module.
STARTING AND OPERATING
The automatic braking function may only be

applied if the vehicle deceleration is not enough
to avoid colliding with a detected obstacle.
The automatic braking function may not be

applied fast enough for obstacles that move
toward the rear of the vehicle from the left and/
or right sides.
The automatic braking function can be

enabled/disabled from the Customer Program-
mable Features section of the Uconnect system.
ParkSense will retain its last known configura-

tion state for the automatic braking function
through ignition cycles.
The automatic braking function is intended to
assist the driver in avoiding possible collisions with
detected obstacles when backing up in REVERSE
gear.
NOTE:
The system is designed to assist the driver and

not to substitute the driver.
The driver must stay in full control of the

vehicle's acceleration and braking and is
responsible for the vehicle's movements.
117
4