Vehicle Security System - If Equipped; To Arm The System - Jeep WRANGLER 2020 Owner's Manual

NOTE:
With Remote Start, the engine will only run

for 15 minutes.
Remote Start can only be used twice.

If an engine fault is present or fuel level is

low, the vehicle will start and then shut down
in 10 seconds.
The parking lights will turn on and remain on

during Remote Start Mode.
For security, power window operation is

disabled when the vehicle is in Remote Start
mode.
The ignition must be placed in the ON/RUN

position before the Remote Start sequence
can be repeated for a third cycle.
All of the following conditions must be met
before the engine will Remote Start:
Gear selector in PARK

Doors closed

Hood closed

Swing gate closed

Hazard switch off

Brake switch inactive (brake pedal not

pressed)
Battery at an acceptable charge level

Fuel meets minimum requirement

System not disabled from previous Remote

Start event
Vehicle Security system not active

Malfunction Indicator/Check Engine telltale

is not illuminated
Water In Fuel telltale is not illuminated

Wait To Start telltale is not illuminated

For additional functions of the Remote Start
system, see Ú page 22.
WARNING!
Do not start or run an engine in a closed

garage or confined area. Exhaust gas
contains Carbon Monoxide (CO) which is
odorless and colorless. Carbon Monoxide is
poisonous and can cause serious injury or
death when inhaled.
Keep key fobs away from children. Opera-

tion of the Remote Start system, windows,
door locks or other controls could cause
serious injury or death.
GETTING TO KNOW YOUR VEHICLE
VEHICLE SECURITY SYSTEM — IF EQUIPPED
The Vehicle Security system monitors the
vehicle doors for unauthorized entry and the
ignition switch for unauthorized operation.
When the alarm is activated, the interior
switches for door locks are disabled. The
Vehicle Security system provides both audible
and visible signals. If something triggers the
alarm, the Vehicle Security system will provide
the following audible and visible signals: the
horn will pulse, the park lamps and/or turn
signals will flash, and the Vehicle Security Light
in the instrument cluster will flash.
T A T S
O RM HE YSTEM
Follow these steps to arm the Vehicle Security
system:
1. Make sure the vehicle's ignition is placed
in the OFF position.
2. Perform one of the following methods to
lock the vehicle:
Push lock on the interior power door lock

switch with the driver and/or passenger
door open.
25
2