Blue Indicator Lights; Gray Indicator Lights; Onboard Diagnostic System - Obd Ii - Jeep WRANGLER 2020 Owner's Manual

Cruise Control SET Indicator Light —
If Equipped With Base Instrument Cluster
This indicator light will illuminate
when the cruise control is set
Ú page 162.
Selec-Speed Control Indicator Light —
If Equipped
This light will turn on when
"Selec-Speed Control" is activated.
To activate "Selec-Speed Control",
ensure the vehicle is in Four - Wheel Drive
(4WD) Low and push the button on the
Instrument Panel.
NOTE:
If the vehicle is not in 4WD Low, "To Enter
Selec-Speed Shift to 4WD Low" will appear in
the instrument cluster display.
B I L
LUE NDICATOR IGHTS
High Beam Indicator Light
This indicator light will illuminate to
indicate that the high beam
headlights are on. With the low beams
activated, push the multifunction
lever forward (toward the front of the vehicle) to
turn on the high beams. Pull the multifunction
lever rearward (toward the rear of the vehicle) to
turn off the high beams. If the high beams are
off, pull the lever toward you for a temporary
high beam on, "flash to pass" scenario.
G I L
RAY NDICATOR IGHTS
Cruise Control Ready Indicator Light —
If Equipped With Base Instrument Cluster
This light will turn on when the cruise
control has been turned on, but not
set.
GETTING TO KNOW YOUR INSTRUMENT PANEL
Active Speed Limiter Ready Indicator
Light — If Equipped With A Base
Instrument Cluster
This light will turn on when the Active
Speed Limiter is on, but not set.
ONBOARD DIAGNOSTIC SYSTEM — OBD II
Your vehicle is equipped with a sophisticated
Onboard Diagnostic system called OBD II. This
system monitors the performance of the
emissions, engine, and transmission control
systems. When these systems are operating
properly, your vehicle will provide excellent
performance and fuel economy, as well as
engine emissions well within current
government regulations.
135
3