The Stand-By/Operate Mode; The Contrast & Brightness Mode - Barco ACTAS 2 Owner's Manual

The 'Stand-by/operate' mode
This function puts the selected projector or the whole
configuration into or out of the 'Operate' mode.
Note : The 'Operate' mode of the projector is not simply
toggled, but forced into the desired state.
The 'Contrast & brightness' mode
With this function being set, the brightness & contrast of
the addressed projector can be incremented or
decremented using the button keys on the ACTAS
Control Unit just as performed by using control keys on
a Remote Control Unit.
Note: If the 'Text' mode of the projector is switched on,
the bar scales will be displayed during adjust-
ments. Please refer to your owner's manual of the
projector for details.
5975636 ACTAS 2 170297
<<<REMOTE CONTROL>>>
ENT: stdby / operate
çè
: other function
Press 'ENTER'
è
: proj 6 operat.
ç
: proj 6 standby
é
: all operational
ê
: all standby / EXIT
è
Press ' ' to put the projector 6 into the
ç
operational mode. Press '
projector 6 out of the operational mode.
é
Press ' ' to put all projectors into the
operational mode.
ê
Press ' ' to put all projectors out of the
operational mode.
Press 'EXIT' to quit.
<<<REMOTE CONTROL>>>
ENT: contr & bright
çè
: other function
Press 'ENTER'
è
: inc brightness
ç
: dec brightness
é
: inc contrast
ê
: dec contrast / EXIT
è
Press ' ' to increment the brightness.
ç
Press ' ' to decrement the brightness.
é
Press ' ' to increment the contrast.
ê
Press ' ' to decrement the contrast.
Press 'EXIT' to quit.
ACTAS software
EXIT
' to put the
EXIT
2-25