Get Reference Menu; Select / Edit Setup Menu; Selecting A Setup Memory Block - Barco ACTAS 2 Owner's Manual

ACTAS software

GET REFERENCE MENU

This function is used in aligning multiple projectors
forming a projection wall. It requests parameters' set-
tings from the reference projector. The reference values
are then used to align other projectors. The projector
that is used as the reference will be remembered by the
ACTAS Control Unit as an adjusted projector in the
configuration.
In the 'Get reference' command menu, press the <EN-
TER> key to enter the path, then press the <ADJUST>
key to start up the process :
1. The brightness and contrast values are read from the
projector and stored into the displayed setup memory
block (e.g. nr 6).
2. The light output reference values for high and low
level test pictures are measured and stored into the
same setup block.
3. An end message will be displayed to report the
termination of the process.
4. Press the <ADJUST> key to repeat.
Press the <EXIT> key to return.
In the color alignment of a single stand-alone projector,
this step need not be done.

SELECT / EDIT SETUP MENU

This function allows you to select a Setup block and edit
settings of the Setup.

Selecting a Setup memory block

After the <ENTER> key is pressed in the 'Select/edit
setup' menu, the 'Select setup' menu will be displayed.
It gives the number of the current block (e.g. Setup 2),
the selected projector type (e.g. 808s) and the phosphor
type (e.g. auto).
Follow the steps below to select a Setup block :
u é
Use the ' ' key and '
lower number Setup block;
u
Press the <ENTER> key to save the change: a
message will be displayed to report the saving pro-
cess;
Or press the <EXIT> key to return without changes:
a message will be displayed to report the reverting
process.
2-8
ê
' key to access the higher or
ENTER : get reference
çè
: other command
Press the 'ENTER' key
Get reference
into setup nr
(Ref kind G2 )
ADJ : start
Press the 'ADJUST' key
Bri, contr,
48%, 60%,
Low reference : RGB
123, 456, 789
References stored
ADJ: again
ENTER : select / edit
setup
çè
: other command
Press the 'ENTER' key
Select setup
2 : ( 808s auto )
ADJ : edit
ENT : select
é
Press the ' ' key
Select setup
3 : ( auto auto )
ENT: select
Press the 'ENTER' key
Select setup
3 : ( auto auto )
ADJ : edit
ENT : select
6
/ EXIT
e.g.
/ EXIT
éê
/ : change
/ EXIT: quit
éê
/ : change
/ EXIT: quit
éê
/ : change
/ EXIT: quit
5975636 ACTAS 2 170297