Send Again - Barco ACTAS 2 Owner's Manual

Aligning multiple projectors

Send Again

This command is only to be used in the rare cases where
the ACTAS adjustments in the previous step were not
carried out on the same projector block as on the one
that is used by the application. If the ACTAS Interface
was chosen to act as the test picture generator, check
if there really is no way to make it imitate the target
source.
Tip :
In installations where the source types or frequencies
are switched regularly, it can be useful to use the 'send
again' command to copy the color settings to the other
blocks of the projector. This works best if no switching is
done to the source types that involve different projector
circuitry in the video path: for example, switching from
RGBS to RGsB causes no changes, but switching from
RGBS to Video could.
4-6 5975636 ACTAS 2 170297