Power(Mains) Connection; On Safety; Power Requirements; Power Adaptation - Barco ACTAS 2 Owner's Manual

ACTAS set-up
POWER (MAINS) CONNECTION

On safety

This product should be operated from an AC power source.
Operating AC power voltage of the projector :
Part No. : R9827961
Part No. : R9827968
The part number of the product is given on the labels
pasted on the flight case and on the Interface unit.

Power requirements

Power requirement for electrical equipment differs from
country to country. Please ensure that this apparatus
meets the power requirement in your country.
If the power cord of the Interface is equipped with a
ANSI73.11 plug : the factory preset power voltage is 120
VAC 60mA 50/60 Hz.
If the power cord of the Interface is equipped with a CEE7
plug : the factory preset power voltage is 230 VAC 40mA
50/60 Hz.
If in doubt, consult a qualified technician for voltage
adaptation.

Power Adaptation

To adapt the power voltage of the Interface unit, please
proceed as follows :
Warning :
Unplug the power cord before
proceeding with the power voltage
adaptation of the Interface unit.
1. Remove the bottom housing to access the interface
module :
K
Place the ACTAS Interface unit upside down on
a table;
K
Pry the four screw caps off using a screwdriver;
K
Turn out the sunk screws using a Phillips screw-
driver;
K
Separate the bottom housing from the top hous-
ing.
1-6
230V (AC)
120V (AC)
TO PREVENT FIRE OR ELECTRICAL SHOCK,
DO NOT EXPOSE THIS EQUIPMENT TO
RAIN OR MOISTURE
WARNING
ANSI 73.11 plug
CEE 7 plug
5975636 ACTAS 2 170297