ENGINE DISASSEMBLY / INSPECTION -
TOP END
VALVE COVER REMOVAL
NOTICE
The valve cover, camshafts, cylinder head, cylinder and
piston can be serviced with the engine installed in the
chassis.
1. If needed, remove the spark plug wire from the
engine.
2. Remove dirt and debris from valve cover area.
3. Remove the three valve cover shoulder bolts
w
isolators
using a T40 driver.
4. Carefully lift valve cover from the engine and remove
it out of the right-hand rear wheel well area.
5. Replace isolators after each use
6. Replace Valve cover seal
r
7. Remove the spark plug
a shop towel to prevent anything from falling into the
combustion chamber (if further engine disassembly
is required).
9850043 R01 - 2017-2021 RANGER 500 / 570 Service Manual
© Copyright Polaris Inc.
q
and
w
e
if oil leaks are evident
. Stuff spark plug hole with
ENGINE / COOLING SYSTEM
CAMSHAFT / CARRIER REMOVAL
NOTICE
The camshafts can be removed with the engine
installed in the chassis.
1. Rotate the engine so the piston is at Top Dead
Center (TDC) on the compression stroke.
NOTICE
To verify TDC, see "Setting TDC (Top-Dead-Center)".
2. Remove the hydraulic cam chain tensioner
the cylinder. Replace the sealing washer
reassembly.
3
t
from
y
upon
3.93