Advertisement
Electrical system
•
Location on the vehicle: under the left fairing, left side, next to auxiliary injection relay.
FAN CONTROL RELAY
•
Location on the electrical circuit diagram: 43
•
Location on the vehicle: under fuel tank, right side, next to rear cylinder head.
HIGH BEAM LIGHTS RELAY
•
Location on the electrical circuit diagram: 5
•
Location on the vehicle: under the top fairing, near the headlamp.
SAFETY RELAY
•
Location on the electrical circuit diagram: 20
•
Location on the vehicle: under fuel tank, right side, near the fan control relay.
Electrical system installation
INTRODUCTION
Scope and applicability
The purpose of this document is to exclusively define the vehicle electrical cable harness routing, its
positioning and how it is secured to the frame, instrument panel support and saddle mounting; any
critical issues and particular checks on connections and routing, in order to achieve the vehicle reliability
targets. Other details not required for this purpose may be vague or even incorrect.
Materials used and corresponding quantities
The electrical system consists of the following cable harnesses and parts:
•
1 Main Cable Harness
•
1 License Plate Lamp Cable Harness
•
25 Large plastic clamps (4.5x280).
•
9 Small plastic clamps (2.5x160).
•
4 Rubber clamps (long).
•
5 Rubber clamps (short).
•
5 Connector supports.
•
8 Cable grommets
•
3 Cable guides.
•
2 Cable guides for ABS sensors.
•
1 Cable grommets
•
1 Front headlamp water seal gasket.
•
2 Front headlamp water seal gaskets.
Motorcycle division
The wiring timing is subdivided in three essential sections, as indicated in the figure.
1. Front section
ELE SYS - 96
Caponord 1200 - Caponord 1200 Rally
Advertisement
