Advertisement
Engine
•
Fit tool on crankshaft matching the fly-
wheel key.
•
Tighten the screw on the crankshaft.
•
Turn crankshaft until the tool "V" is
positioned at the front cylinder.
•
Tighten the two pins of the tool.
•
Screw without tighten the nuts on cam-
shaft gears.
•
Install the camshafts on front head,
aligning them using the suitable pins.
Specific tooling
020719Y Timing pin
•
Fit cam tower and tighten the eight
screws working in a diagonal se-
quence and in stages.
•
Pre-tighten the gear nut on the camshaft.
REFIT THE NUT WITH THE MACHINED SURFACE FACING THE GEAR (THE MATERIAL ACRO-
NYM SHOULD BE VISIBLE).
ENG - 338
Caponord 1200 - Caponord 1200 Rally
Advertisement
