Advertisement
Engine
•
To reduce the installation force neces-
sary, score an incision approximately
0.5 mm (0.02 in) deep (without cutting
into the steel shell) in each semi-bush-
ing in the area indicated in the figure.
•
Remove the bushings with the crank-
case cold, using a press and the spe-
cific tool and pushing inward from the
outside of the crankcase.
Specific tooling
020726Y Bushing extractor
Installing
•
The orientation of the semi-bushings
must match the specifications indica-
ted in the drawing as closely as possi-
ble.
NOTE
WHEN REPLACING THE SEMI-BUSHINGS ALONE, THE
NEW COMPONENTS MUST BE THE SAME COLOUR AS
THE REMOVED COMPONENTS. IF THE COLOUR OF THE
OLD COMPONENTS IS NO LONGER VISIBLE, USE THE
TABLE TO IDENTIFY THE CORRECT COMPONENTS, RE-
FERRING TO THE CRANKCASE AND CRANKSHAFT
CLASSES.
Key:
* Semi-bushing joint line.
•
Fit the new bushings with the crank-
case cold, using a press and the spe-
cific tool and pushing outward from the
inside of the crankcase, until the punch
comes into contact with the crankcase
surface.
Specific tooling
020727Y Bushing punch
ENG - 358
Caponord 1200 - Caponord 1200 Rally
Advertisement
