Suspensions
•
Insert the retainer ring in its position.
•
Fit the dust gaiter with the specific tool.
Specific tooling
AP8140189 Tool for fitting oil seal for 43 mm
(1.69 in) diameter hole
AP8140146 Weight
•
Fit the pumping member inside the
stem, paying attention that it is placed
inside the seat of the stem.
CAUTION
PAY PARTICULAR ATTENTION TO THE CORRECT INSER-
TION OF THE PUMPING MEMBER INSIDE THE STEM. IN
THE RIGHT POSITION, THE PUMPING MEMBER SHOULD
NOT TURN. ALSO DURING THE SCREW TIGHTENING AL-
WAYS CHECK THAT THE PUMPING MEMBER IS NOT
TURNING.
Filling oil
•
Place the sleeve upright in a vice fitted with protection jaws.
•
Compress the sleeve in the stanchion. Put a support under the stem so as to leave it com-
pressed.
SUSP - 396
Caponord 1200 - Caponord 1200 Rally