Pre-delivery
•
Insert the four screws (4) in the proper
seats present in the two side bumpers.
•
Insert the additional headlamps in the
screws (4).
•
Insert the four washers (5) in both ad-
ditional headlamps.
•
Insert the four nuts (6) in both addition-
al headlamps without tightening.
•
Only tighten the rear nuts (6) to the tor-
que of 10 Nm (7.38 lb ft), the front nut
indicated in the figure is only tightened
after the adjustment of the light beam
of the additional headlamps.
•
Apply three cable ties (7) in both addi-
tional headlamps as indicated in the
figure.
PRE DE - 564
Caponord 1200 - Caponord 1200 Rally