Agilent Technologies 86038B User Manual page 300

N O TE
300
• If the TLS output power is off by more than 0.5 dB, or
there is no output signal, check the optical connections
and finally replace the TLS module.
Low SSE output on the TLS:
should test the Low SSE output on the TLS. Follow the steps above, using
TLS Output 1. If there is a power discrepancy between the TLS and MWM,
use the power meter to isolate where the failure lies.
Agilent 86038B Photonic Dispersion and Loss Analyzer, Second Edition
If using a MWM for wavelength correction, you