Lock Led Indications - Sargent ASSA ABLOY IN100 Series Installation Instructions Manual

9

Lock LED Indications

Lock has three (3) LEDs. They support an optical scheme with red, yellow and green. Indication scheme described by figures below:
Card + PIN access (configurable)
Card access (configurable)
Access granted, EAC offline or online
Access denied, EAC online
Force closed in remote open/office mode
Busy blink, com hub busy w/other locks
Access denied, EAC offline
*Lock mechanism is blocked when closing
Error in lock, maintenance required
Time to replace battery
Battery reached end of life, lock disabled
USB cable detection action occurred
Privacy mode activation (inside)
Privacy mode activation (outside)
Privacy mode deactivation (inside)
*When lock mechanism is blocked (lock jammed) lever must be turned to release lock mechanism.
Some special LED indication schemes are used during lock maintenance actions:
Enter configuration mode
Lock NORMAL OPERATION LED indication
EAC response
time
Tamper
Lock MAINTENANCE OPERATION LED indication
Enter PIN
One yellow flash after card, two flashes
before PIN (.125 second)
One yellow flash (.25 second)
One green flash (1 sec.)
One red flash (1 sec.)
Five yellow flashes & one red flash (.25 sec.)
Continuous yellow flashes (.25 sec. every sec.)
Three red flashes (.5 second each)
Continuous red flashes (.125 sec. every 1 sec.)
Ten red flashes (.125 sec. each)
(Repeated every 5 sec. if lock can't close)
Ten red flashes (.125 sec. each)
repeated every 5 sec.
Continuous yellow flashes
(.25 sec. every 5 sec.)
Continuous red flashes (.25 sec. every 5 sec.)
Five yellow flashes (.25 second each)
Ten red flashes (.125 sec. each, 1 per sec.)
then one red flash every 3 sec. for 120 sec.
One flash (1 sec.) and 1 beep (if available)
Three red flashes (.125 sec.)
Five yellow flashes (.125 sec. each)
20 1-800-810-WIRE • www.sargentlock.com • A8190E
IN100 Series
Mortise Lock
Installation Instructions