Door Hardware - Heartland VALUE Series Assembly Manual

PARTS REQUIRED:
x2
BEGIN
Place bolt on OO in open position with bolt end 3/8" (9,5 mm) down from frame. Bolt is
1
open when loop is contacting base (Fig A).
2
Mark and pre-drill holes for screws. Install bolt with screws supplied.
Drill 5/16" (7,9 mm) hole deep enough for bolt to slide into.
3
Place bolt on OO in open position with bolt end 1/2" (12,7 mm) up from floor.
Bolt is open when loop is connecting base (Fig. B).
Mark and pre-drill holes for screws. Install bolt with screws supplied.
4
Drill 5/16" (7,9 mm) hole deep enough for bolt to slide into.
LEFT
DOOR

DOOR HARDWARE

x8
3/4" (1,9 cm)
Fig. A
OPEN POSITION
Spring is loose.
Fig. B
Loop contacts
OPEN POSITION
Spring is loose.
FLOOR
60
5/16" (7,9 mm) Drill Bit
OVER DOOR
FRAME
OO
x4
base
1/2"
(12,7 mm)
5/16" (7,9 mm)
drill for bolt:
1" (2,5 cm) deep.
3/8" (9,5 mm)
with bolt
in open
position.
PRE-DRILL
(4) HOLES
Loop contacts
base
OO
PRE-DRILL
(4) HOLES
x4
5/16" (7,9 mm)
drill for bolt:
1" (2,5 cm) deep.