Heartland VALUE Series Assembly Manual page 41

PARTS REQUIRED:
BEGIN
1 Align rafters over the wall studs.
Check that you have the measurements shown.
Secure middle rafters with (2) 3" screws angled into doubler (Fig. A).
Secure (2) end rafters with (2) 3" screws into outside of each end rafter (Fig. B).
Secure rafters on opposite side.
Maintain the measurements between rafters.
10' x 10'
Rafter with
ONE GUSSET
facing inward.
Flush to
outside
of panel
Maintain the measurements between rafters.
10' x 14'
24-3/8"
(62 cm)
Rafter with
ONE GUSSET
facing inward.
Flush to
outside
of panel
FINISH
Your rafters are now installed.
RAFTER INSTALLATION
10x10' 10x14'
x4 x6
x2 x2
x24 x32
DIMENSIONS ARE FROM OUTSIDE OF WALL PANELS.
DIMENSIONS ARE TO CENTER
24"
24-3/8"
(61 cm)
(62 cm)
Fig. A
Flush to inside
of panel
DIMENSIONS ARE FROM OUTSIDE OF WALL PANELS.
DIMENSIONS ARE TO CENTER OF RAFTERS.
24" 24"
(61 cm) (61 cm)
Fig. A
Flush to inside
of panel
Two-Gusset
Preassembled
One-Gusset
Preassembled
OF RAFTERS.
24" 24"
(61 cm) (61 cm)
ALIGN OVER
STUDS
Fig. B
3" (7,6 cm)
Screws angled
into top plate
24" 24"
(61 cm) (61 cm)
ALIGN OVER
STUDS
3" (7,6 cm)
Screws angled
into top plate
39
3" (7,6 cm)
24-3/8"
(62 cm)
Rafter with
ONE GUSSET
facing inward.
Flush to
outside
of panel
(2) 3" (7,6 cm)
Screws angled
in end rafter and
into doubler.
24" 24-3/8"
(61 cm) (62 cm)
Fig. B
(2) 3" (7,6 cm)
Screws angled
in end rafter and
into doubler.
Rafter with
ONE GUSSET
facing inward.
Flush to
outside
of panel