PARTS REQUIRED:
x1
x1
BEGIN
Arrange back gable parts GPP on the flat side, as shown.
1
Measure and mark the center of the 27-3/8" x 52-1/4" gable center panel.
Secure with 1-1/2" nails spaced 6" apart along edge.
Place end panels on GPP flush to installed panel and secure with 1-1/2" nails spaced 6" apart along edge.
2
Repeat for right panel.
FINISH
Your back gable unit is now assembled.
BACK GABLE UNIT
23-7/8" x 52-1/4"
x1
(60,6 x 132,7 cm)
Install gable panels with the primed side facing up.
1-3/4"
(4,4 cm)
GPP
1-1/2"
(3,8 cm)
Flush
x2 GPP
2 x 4 x 43-3/16" (5,1 x 10,2 x 109,7 cm)
1-3/4"
(4,4 cm)
1-1/2" (3,8 cm)
Nails
6"
(15,2 cm)
27-3/8" x 52-1/4"
1-1/2" (3,8 cm)
Nails
6"
(15,2 cm)
Flush
Mark
40
x24
1-1/2" (3,8cm)