Heartland VALUE Series Assembly Manual page 45

PARTS REQUIRED:
Pre - assembled
BEGIN
1
Measure 1-1/2" (3,8 cm) down from top plate and mark at each side as shown.
Set back gable unit centered on back wall top plate. Fasten with (1) 2" nail on each side.
BE SURE GABLE IS CENTERED ON WALL BEFORE NAILING.
Continue securing panels to top plate and rafter with 2" nails spaced 6" apart.
2
Working inside, secure gable unit with (2) 3" screws angled into each GPP at an angle (Fig. A).
NAIL FIRST
1-1/2"
2" (5,1 cm)
(3,8 cm)
Measure and
Mark
FINISH
Your back gable unit is now installed.
BACK GABLE UNIT INSTALLATION
Top Plate
x4
x57
2" (5,1 cm)
6"
(15,2 cm)
Fig. A
3" (7,6 cm)
Screws
43
3" (7,6 cm)
GPP
1-1/2"
(3,8 cm)
Measure and
Mark
NAIL FIRST
2" (5,1 cm)