Heartland VALUE Series Assembly Manual page 40

10x10' 10x14'
PARTS REQUIRED:
x10 x14
x12
x16
x120 x168
BEGIN
Place two rafter-halves on floor and flush base ends (with nub) in the corners of 10' wall.
1
Place RL under peak of rafters as a temporary support.
Secure gusset to rafters with 2" nails following the pattern shown (FIg. A).
Flush
1/4" 1/4"
(1,9 cm) (1,9 cm)
Fig. A
SET ASIDE THESE TWO RAFTER ASSEMBLIES.
Depending on your shed size, build 4 or 6 rafter assemblies with (2) gussets (Fig. C).
2
Place two rafter-halves on floor and flush base ends (with nub) in the corners of 10' wall, as shown in step 1.
Flush rafters at peak. Place RL under peak of rafters as a temporary support.
Secure gusset to rafters with 2" nails following the pattern shown (FIg. A).
3
Flip over rafter assembly and fasten second gusset to other side with 2" nails (FIg. C).
Fig. B -
Build 2
FINISH
Your rafters are now assembled.
Remove RL and screws from floor.
RAFTERS
6 x 24" (15,2 x 60,9 cm)
Pre-assembled
2" (5,1 cm)
Build (2) rafter assemblies with(1) gusset (Fig. B).
Flush
in corner
x1 RL
2 x 4 x 24" (5,1 x 10,2 x 61 cm)
120"
(304,8 cm)
Fit base of rafters in corners
of 10' wall.
Flush at peak
Fig. C -
Build 4 or 6
38
Temporary Support
Flush
in corner
Temporary
Support RL