Heartland VALUE Series Assembly Manual page 43

PARTS REQUIRED:
x2 JGA
19/32" x 2-1/2" x 12-7/8" (1,6 x 7,6 x 32,7 cm)
x4
KX
19/32" x 2-1/2" X 21-3/4" (1,6 x 7,6 x 55,2 cm)
x1 LKA
19/32" x 2-1/2" x 25-3/4" (1,6 x 7,6 x 65,4 cm)
BEGIN BEGIN
Set 27-3/8" x 50-13/16" gable center
1
1
panel (primed side facing up) on top of
(2) OO, as shown.
Measure and mark the 12" (30,5 cm)
center of the gable panel and
10-1/8" (25,7 cm) from bottom of panel.
2
Arrange trim parts as shown, with all
connections flush.
Secure with (2) 2" finishing nails
in each part.
You are finished with the
temporary supports.
Set them aside.
3
Turn the panel over (with trim attached).
Secure each part with 3/4" screws
between nails, as shown.
Snip off the protruding nails.
FINISH
Your gable panel with hay loft trim is now assembled.
FRONT GABLE HAY LOFT TRIM
23-7/8" x 50-13/16"
x1
(60,6 x 129,1 cm)
Install trim on primed side of panel.
x14
2" (5,1 cm)
x1 OO Temporary Brace
69" (175,3 cm) Door Stiffener
12"
(30,5 mm)
KX
KX
KX
Center
41
x20
3/4" (19 mm)
OO
Temporary Support
12"
(30,5 mm)
2" (5,1 cm)
Finishing Nails
KX
Flush all
connections
10-1/8"
(25,7 mm)
27-3/8" x 50-13/16"
3/4" (19 mm)
Screws