Heartland VALUE Series Assembly Manual page 52

PARTS REQUIRED:
47-7/8 x 48"
x1
(121,6 x 121,9 cm)
3
Install 47-7/8" x 48" roof panel
flush to the installed panel and
flush at the peak (Fig. B).
Secure panel with (1) 2" nail
in each corner.
Move to the opposite end.
Using the unattached end of
the panel as a lever, move the panel
side-to-side until the top corner is flush
to the peak (Fig. B) and there is a 3/4"
measurement on the rafter (Fig A).
Secure panel with (1) 2" nail in each corner.
4
Install 23-7/8" x 48" roof panel flush to
the installed panel and flush at the peak
(Fig. B). Secure panel with (1) 2" nail in
each corner.
Move gable end rafter edge until it is
1/2" from the 23-7/8" x 48" roof panel
(Fig. C).
Finish securing panel with (1) 2" nail
in each corner.
5
Maintain spacing between the center of the rafters at the lower edge of the panels (Fig. D).
Secure panels with (1) 2" nail into each rafter, as shown.
Move to the top of the panel and keep spacing between the center of the rafters.
Secure panels with (1) 2" nail into each rafter.
24-3/8"
(62,9 cm)
2" (5,1 cm) Nails
10' x 14' ROOF PANELS
23-7/8 x 48"
x1
(121,6 x 121,9 cm)
1/2"
(1,2 cm)
Fig. C
Gable
End Rafter
Gauge Block
Fig. A
3/4"
(1,9 cm)
NOTE:
Measurements from inside of gable panels
24" 24"
(60,9 cm) (60,9 cm)
Flush
Flush
Fig. D
24"
24"
(60,9 cm) (60,9 cm)
50
x16
2" (5,1 cm)
Flush at
peak
Fig. B
2" nail
in each
corner
24-3/8"
24"
(62,9 cm)
(60,9 cm)