Heartland VALUE Series Assembly Manual page 39

PARTS REQUIRED
OY
x1
2 x 3 x 72" (5,1 x 7,6 x 182,9 cm)
BEGIN
1
Measure, mark and center doubler OY on top plate, over door. Flush OY to face of wall panels (Fig. A).
Secure ends of OY with (2) 3" nails, as shown.
2
Continue securing OY with (3) 3" nailss spaced evenly. NOTE: Set (3) middle nails at an angle (Fig. A).
Do not allow nails to protrude below top plate.
FINISH
Your over door doubler is now installed.
OVER DOOR DOUBLER
3" (7,6 cm)
Nails
Fig. A
x5
3" (7,6 cm)
OY
Mark
Center
3" (7,6 cm) Nails
set-in at an angle.
Flush to panel.
37
3" (7,6 cm)
Nail