Heartland VALUE Series Assembly Manual page 9

• If your shed came with a separate floor kit, then please use the instructions supplied with that kit to assemble your floor.
• See the FLOOR LEVELING section on page 11 for recommended methods and suggested materials to properly level your floor,
as this will vary depending on your specific site.
• If you choose to install your floor on a concrete slab, refer to page 9.
• If you choose to build your own wood floor foundation, refer to page 10.
REINFORCED WOOD FLOOR FRAME (OPTIONAL)
IMPORTANT! Depending on your specific use you may want to construct a heavy duty floor frame by adding additional floor joists
(shown below as shaded). Below is a list of additional materials (not included):
10x10'
x2
2 x 4 x 10' (5,1 x 10,2 x 304,8 cm) Treated Lumber
cut to 2 x 4 x 117" (5,1 x 10,2 x 297,2 cm)
x8
3" (7,6 cm) hot-dipped galvanized nails
10x14'
x3
2 x 4 x 10' (5,1 x 10,2 x 304,8 cm) Treated Lumber
cut to 2 x 4 x 117" (5,1 x 10,2 x 297,2 cm)
x12
3" (7,6 cm) hot-dipped galvanized nails
NOTE: Use a minimum of 5/8" (1,6 cm) Oriented Strand Board (OSB)
x4
x1
2" (5,1 cm)
ADDITIONAL MATERIALS
FOUNDATION OR FLOOR MATERIALS
FLOOR PANELS (Not Included)
You will need floor panels and nails to complete your floor.
Floor panel sizes and quantities are shown below.
10x10'
5/8" x 48" x 96"
(1,6 x 121,9 x 243,8 cm)
1 lb. of 2" (5,1 cm) Hot
Dipped Galvanized
Box-Type Nails.
Standard 16" (40,5 cm) spacing
Optional 12" (30,5 cm) spacing
Standard 16" (40,5 cm) spacing
Optional 12" (30,5 cm) spacing
x5
x2
2" (5,1 cm)
7
10x14'
5/8" x 48" x 96"
(1,6 x 121,9 x 243,8 cm)
1 lb. of 2" (5,1 cm) Hot
Dipped Galvanized
Box-Type Nails.