Heartland VALUE Series Assembly Manual page 47

PARTS REQUIRED:
x1
Roof panels may cause serious injury until securely fastened.
Note: Install all roof panels with the rough side up (painted grid lines).
BEGIN
1
Place (1) 48" x 96" panel on rafters with
a 3/4" measurement on the rafter (Fig. A)
and the panel flush at the peak (Fig. B).
Secure panel with (2) 2" nails in the corners.
Gauge Block
2
Move to the opposite end.
Using the long edge of the panel as a lever,
move the panel side-to-side until the top corner
is flush to the peak (Fig. B) and there is a 1/2"
measurement on the gable end rafter (Fig. C).
Secure panel with (2) 2" nails in the corners.
10' x 10' ROOF PANELS
48 x 96"
(121,9 x 243,8 cm)
Two Nails
3/4"
(1,9 cm)
Fig. A
Fig. C
3/4" GAUGE
BLOCK
1/2"
(1,2 cm)
Gable
End Rafter
45
x4
2" (5,1 cm)
Fig. B
Fig. B
Two
Nails
Flush at
peak
Flush at
peak