Table of Contents
Advertisement
e.g.) Rapid deceleration from 3000rpm
When the quick stop mode is OFF
Rotation
speed
Display
UTMⅡ
rotation
signal
4-4.
Calibration procedure for the encoder
(only when using the encoder)
*
*
*
*
:
Encoder pulse (ENCODER)
Set the number of pulse input from the rotary encoder per a rotation.
<Setting range>
* The following setting items only available when OTHER is selected, and arbitrary number of
Other pulse (OTHER PUL.)
Set the number of pulse input from the rotary encoder per a rotation.
<Setting range>
19
3000rpm
3000rpm
0rpm is displayed after 1s.
Cycle (5ms)
(1)
Encoder pulse
(2)
Unit
(3)
Direction
(4)
Minimum scale
(5)
Zero clear
Be sure to perform the setting.
NOT USE, 720PULSE, 1080PULSE, 1440PULSE, 1800PULSE,
2000PULSE, 2880PULSE, 3600PULSE, 4000PULSE, OTHER
pulse input can be set.
- Other pulse
(These items only available in case the Encoder pulse is set to OTHER)
1 to 9999
When the quick stop mode is ON
Rotation
speed
0rpm
Display
0rpm
UTMⅡ
rotation
signal
Set the number of pulse input from the rotary encoder
per a rotation.
Set the unit of value to display.
Set the rotation direction of UTMⅡ.
Set the minimum unit of rotary encoder such as scale
interval and scale division.
(optional if there is no change)
Set the timing to reset the angle display to zero.
(optional if there is no change)
4 Torque Settings
3000rpm
0rpm
3000rpm
0rpm is displayed after 4 cycles.
Cycle (5ms)
After 4 cycles (20ms)
0rpm
Chapter
4
19
Advertisement
Table of Contents
